Martha Stewart shows us how to make the perfect hard-boiled egg (2024)

FAQs

Martha Stewart shows us how to make the perfect hard-boiled egg? ›

Carefully place the eggs in a large saucepan; add cold water to cover by one inch, and bring to a rolling boil. Cover pan; remove from heat. Let stand 12 minutes, then drain and rinse under cool water. To store, keep eggs unpeeled in the refrigerator, up to 4 days.

You might have heard that you should drop your eggs into room temperature or cold water and then bring the water to a boil. This is a myth. In our tests, bringing the water to a boil first and then lowering the eggs into the bath made for easy peeling and more accurate timing.

Once the water is at a rolling boil, turn off the heat and cover the pot with the lid. Allow the eggs to sit in the hot water for the following times according to the desired doneness: 3 minutes for SOFT boiled; 6 minutes for MEDIUM boiled; 12 minutes for HARD boiled. Prepare a bowl of ice water.

Baking Soda

According to our friends at Delish, adding a teaspoon of baking soda to your boiling pot of water will help the shell peel off seamlessly. Why? The alkaline in the baking soda will help your egg whites loosen up from the shell, making it easier to peel.

The vinegar in the water makes the eggs easier to peel. Here's why: The vinegar's acid not only dissolves some of the calcium carbonate in the shell, it also helps the whites set faster. Running the hard-boiled eggs under cold running water as you're peeling, meanwhile, helps the shell separate from the membrane.

Fill a saucepan about a quarter of the way with cold water. Place the eggs in a single layer at the bottom of the saucepan. Add more water so that the eggs are covered by at least an inch or two of water. The more eggs that are crowding the pan the more water you should have over the eggs.

Bring water to a boil over high heat, then reduce heat to moderately high and cook eggs at a gentle boil, uncovered, 10 minutes. Pour off hot water. If using eggs right away, shake pan gently so eggs bump into one another (to crack shells).

Lower the heat slightly – so the eggs don't crack due to being bashed around but water is still at a gentle boil. Start the timer – 6 minutes for runny yolks, 8 minutes for soft boiled, 10 minutes for classic hard boiled, 15 minutes for unpleasant rubbery whites and powdery dry yolks.

For one to four eggs, bring the water to a rolling boil, cover the pot, and turn the heat down to its lowest setting for 12-14 minutes. For five to eight eggs, cook for 15 to 18 minutes. For nine to one dozen eggs, cook for 20 minutes. After cooking, transfer the eggs to a bowl of ice water.

Carefully place the eggs in a large saucepan; add cold water to cover by one inch, and bring to a rolling boil. Cover pan; remove from heat. Let stand 12 minutes, then drain and rinse under cool water. To store, keep eggs unpeeled in the refrigerator, up to 4 days.

Why salt is added to boiling eggs? ›

Hence, this helps the water to attain a temperature higher than 100 ° C before starting to boil. This phenomenon helps cook and hard boil the egg quicker as the addition of salt has increased the boiling point of water. Also, the added salt to the water prevents an egg from cracking during cooking.

Egg white solidifies more quickly in hot, salty water than it does in fresh. So a little salt in your water can minimize the mess if your egg springs a leak while cooking. The egg white solidifies when it hits the salt water, sealing up the crack so that the egg doesn't shoot out a streamer of white.

Since the egg membrane is semi-permeable, water can move in but proteins cannot move out. If a naked egg is placed in the corn syrup the egg will shrink. This is also due to osmosis, but in the opposite direction. The corn syrup is mostly sugar.

It's important to start the eggs in cold water — bringing the water and eggs up in temperature together ensures even cooking and prevents cracking. Bring the water to a rolling boil over high heat, then immediately remove the pan from the heat. Cover, and let stand for 10 minutes. Carefully pour out the hot water.

When an egg is boiled, the proteins present inside the egg get denatured and coagulate. After boiling the egg, the water present in it is absorbed by the coagulated protein through H-bonding.